دارای قابلیت استفاده با برق 220 ولت شهر
-Operating input voltage: DC 11~18 volts - AC 100~240V, 50/60Hz-Charge/discharge power: max. 50/5 Watts-NiCd/MH: 1~15 cells-LiIo/LiPo/LiFe: 1~6 series-Pb: OUTPUT-1: 2~22V-Charge current: 0.1 to 6.0A-Discharge current: 0.1 to 1.0A-No. of cycles: 1 to 5 times-Battery data memories: up to 5 data-Weight: 680g-Dimension: 140x130x45 mm
Operating softwareThe operating program in this charger is executed with mutual links and communications with every component to prevent any possible error, so it introduces the maximum safety. Especially, the charging algorithm is so multifarious that you can select the best program to suit your requirement. The operating software can be upgraded through SUB when it is necessary, by executing upgrade program at PC. And BC6DX has a large LCD for showing various information including charge/discharge graphs during the process.
Dual input powerBC6DX employs the circuit that can be operated at AC(Alternating Current) or DC(Direct Current) input power. For AC input, the charger contains a AC-DC switching power supplier inside, which has maximum output power of 60watts for charging. As a result, it can charge up to 15 cells of NiCd/NiMH and 6 series of Lithium batteries. There may be the limit of feeding current to a higher voltage of battery. Please refer 'Maximum circuit power chart'.
Individual voltage balancer for Lithium batteries inside BC6DX has an individual-cell-voltage balancer inside. So it does not need any balancer separately when charging Lithium batteries (LiIo/LiPo/LiFe) for individual voltage balancing.
Maximum safety BC8DX has individual cell voltage balancers at both outputs. So it does not need any balancer separately when charging Lithium batteries (LiIo/LiPo/LiFe) for voltage balancing.
Monitor the individual voltages on discharge:Delta-peak sensitivity : The automatic charge termination program works on the principle of the Delta-peak voltage detection. (NiCd/NiMH)
Auto-charge current limit : When charging NiCd or NiMH at 'AUTO' current mode, you can set the upper limit of charge current to avoid from feeding high current to the battery. This is very useful when charging the low impedance and small capacity NiMH battery in 'AUTO' mode.
Capacity limit : The charging capacity always calculated by multiple of the charging current and time. If the charging capacity exceeds the limit the process will be terminated automatically when you set the maximum value.
Temperature limit : The temperature of the battery on charging or discharging will be raised by its internal chemical reaction. If you set the limit of temperature the process will be expired forcibly when the limit has been reached.
Processing time limit : You can also restrain the maximum processing time to prevent any possible defect.
Cyclic charging/discharging for NiMH/NiCd batteryPerform 1 to 10 cycles of charge>discharge or discharge>charge continually for battery refreshing and balancing.
PC based analysis using USB communication/Firmware upgradingFor technical expert, BC6DX offers PC based program can analysis the characteristic of the battery via USB port. It shows a graph of voltage, current, capacity and temperature curves. It also shows the individual voltage of each cell in the Lithium battery pack. The firmware can be upgraded from internet download, when the newer version is released.
|درباره ما |
راهنمای خرید |
اقلام موجود |
Iran-Team.com Eshop Design
| 2009 © Allright Reserved